On the release of V3 of Prepar3D I decided to make a clean brake from all that went before and re-install windows 7 and V3 all following NickN's fantastic guide. I was going down through my list of Addon aircraft installing the keepers one by and there
at the bottom of the list was the Antonov AN-2. A keeper for sure

but would it work in Prepar3D V3? I didn't have it in V2 but I cannot remember why. Perhaps it wouldn't install or didn't work properly. I have a look here first to see if there was any Prepar3D compatibility thread but found nothing. I went ahead and ran the installer and Voila set the destination folder to the Prepar3D directory and it installed with issue. Took it for a flight and it all seem to work fine to me. I haven't ever flown this airplane much but it all seems to work fine. The cockpit click spots and switches all seem to work. The trim lever on my joystick didn't work nor did my flap lever but I am thinking the plane has neither. I did of course set it on fire which was fun. Opps, not it wasn't fun it was a learning experience. Has anyone who knows this bird tried it in V3 and can you confirm if it is in fact fully compatible?
EDIT: Yea it look like there are some issues in Prepar3D V3. I see the airplane does have flaps etc. Looks great, Seem to have its own ground shadow which of course is not required in Prepar3D.
Any possible that this aircraft will get an update for Prepar3D V3?